Replacing Kanta Drivers

Modified on Fri, 01 Dec 2023 at 02:36 PM

  • Large Drivers : 
Locate the notch at the 12 O'clock position on the inside edge of the Trim Ring.
Trim Rings are secured using Double-Face tape.
Push the driver's rubber suspension inwards, to protect it from damage and insert the flat blade
of a screwdriver upwards into the notch.
Twist the handle to start prying away the Trim Ring from the Driver.
Go all around it delicately and remove the Ring completely.
Set it aside to be reinstalled later.
Remove the screws holding the Driver to the cabinet.
Pull out Driver from cabinet and unclip the two wires.

Install New Driver and press the Trim ring onto it, pressing firmly over all its surface to ensure it holds safely.

  • Tweeter : 
Remove the Driver located underneath the tweeter as per instructions above, as you will need to catch the tweeter from inside the cabinet once it is released from the cabinet.
Remove the screws holding the tweeter's protective grille and set them and the grille aside to be reinstalled later.
Remove the 3 screws holding the tweeter to the cabinet.
As you remove the last screw, get your hand inside the cabinet and hold the rear of the tweeter.
Once the last screw is removed, bring the tweeter out through the Driver's hole and disconnect it by loosening the 2 set screws on the rear.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons

Feedback sent

We appreciate your effort and will try to fix the article